Installation

For proper operation of either Throttle Rocker® II or the Original Throttle Rocker®: Position the Throttle Rocker® on the throttle grip so that when applying the front brake, the heel of your hand is just OFF the Throttle Rocker®.

If your Throttle Rocker® tends to slip, a rubber grip band is enclosed in the package. Stretch it over your grip, then reinstall the Throttle Rocker® over the band. This should eliminate any slippage that may occur under normal operating conditions. Should you need a free replacement band, send a self addressed stamped envelope to:
Throttle Rocker, Inc.
PO Box 2478
Boulder Creek, California
USA 95006 

Installation Instructions for Throttle Rocker® II

Unzip END A. (Do not remove END B.) Slide enough of the END A portion of the strap through the slot so that the grip can be placed through the loop. Place the Throttle Rocker on the grip and position it so that when you apply the brake, the heal of you hand is just off the Throttle Rocker. Pull END A tight and press the hook & loop material together to hold firmly. The hook & loop material used is a high quality material with both the hook and the loop on the same side.

Should it slip after it has been tightened, a rubber grip band is enclosed in the package. Stretch it over your grip, then reinstall the Throttle Rocker over the band. This should eliminate any slippage that may occur under normal operating conditions. Should you need a free replacement band, send a self addressed stamped envelope to this address:
Throttle Rocker, Inc.
PO Box 2478
Boulder Creek, California
USA 95006